Tool holders with rectangular shank for indexable inserts - Style B Ingestion-build-180956 This is because wide variations

This is because wide variations may occur in the actual inside diameters of steel pipes fitted with flanges of the same size designations to the higher tables of BS 10

This part of BS 5588 provides recommendations and guidance on access and facilities for fire-fighting in buildings

BS EN 60393-2 gives the minimum performance requirements and test severities

the procedures for fat extraction

This part of IEC 60286 is applicable to the tape packaging of electronic components without leads or with lead stumps

Tool holders with rectangular shank for indexable inserts - Style B Ingestion-build-180956 This is because wide variations1 Scope This part of ISO 5610 specifies tool holders with rectangular shank, style B, i. e. with straight shank and cutting edge angle r = 75 for side cutting. These tool holders are primarily intended for indexable inserts made of hard metal or other cutting materials intended to be mounted by clamping and be used for turning operations. NOTE The symbols for the dimensions shown in the tables of this part of ISO 5610 and the corresponding preferred