1-1/4" PVC Push Point Compression Points This unique design combination allows

This unique design combination allows for the female threaded end of the connector to be easily manuvered in order to quickly "FIND" the male thread of the shaft and be connected to it

As the shafts are extracted the tape or line is pulled into the hole which can then be attached to the microduct and installed

There are 2 half pipe indicator lines cut into the point

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

It should be 5/8 of an inch long

1-1/4" PVC Push Point Compression Points This unique design combination allowsThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or