Fire hazard testing - Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products (GWEPT) has-tracked-changes — supports for wind turbines

— supports for wind turbines

It is not intended for use by manufacturers or certification bodies

See BS EN 15347

IT companies who use data storage devices

Improvement of the content of Clause 8

Fire hazard testing - Glowing/hot-wire based test methods. Glow-wire flammability test method for end-products (GWEPT) has-tracked-changes — supports for wind turbines1 Scope This part of IEC 60695 specifies a test method on an end product. It is intended to simulate the effects of thermal stresses produced by an electrically heated source to represent a fire hazard. This test method is used to check that, under defined test conditions, an end product exposed to an electrically heated source has either a limited ability to ignite or, if it ignites, a limited ability to propagate flame. However, the fire hazard