PrintDry Filament Dryer PRO3 titanium this time using two screws

this time using two screws for clamping instead of the one in E3D-v6

It is highly recommended to use the PolyBox™ when printing with PolyMide™ CoPA and to store it in the resealable bag

"What will you make

Use the 3D Printer Compatibility Chart below to determine which Bimetallic Heat Break™ is best suited for your application

Extruder fan for the Craftbot 3

PrintDry Filament Dryer PRO3 titanium this time using two screwsEasily adjust the temperature with 6 presets (35C, 45C, 55C, 65C, 75C, and 85C). Built in timer with a maximum time of 48 hours. Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent