Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Dimensions of the driving system of tool shanks Ingestion-build-146508 SRC-link requirements

SRC-link requirements

Characteristics which apply to other specific recording methods are found in separate standards documents

This International Standard describes an empirical test procedure for assessing the resistance of a coating of paint

Manufacturer of construction products

this can ensure that your products meet the required quality and performance levels

Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools - Dimensions of the driving system of tool shanks Ingestion-build-146508 SRC-link requirements1 Scope This part of ISO 5414 lays down the dimensions of tool chucks (end mill holders) with clamp screws designed for driving flatted cylindrical shanks in accordance with ISO 3338 2 and specifies the clamp screws used. It also gives the maximum diameter of the chuck nose. This part of ISO 5414 defines two types of drive: chucks with bores of d1 20 mm intended for driving cylindrical shank tools with a single flat, these tools being provided with